Wiring Batteries in a Series and Parallel

Wiring your Sealed Lead Acid Batteries in Series and in Parallel

What is a bank of batteries? No, it’s not some kind of financial battery establishment. A sealed lead acid battery bank is the result of joining two or more batteries together for a single application. What does this accomplish? Well, by connecting batteries, you can increase the voltage or amperage, or both. When you need more power, you can construct a battery bank.

The first thing you need to know is that there are 2 ways to successfully connect two or more batteries. The first is Series and the second is Parallel. Lets start with Series

 

Series

 

Series adds the voltage of the two batteries, but keeps the same amperage rating (also known as Amp Hours). For example, these two 6 Volt batteries joined in series now produce 12 Volts, but still have a total capacity of 10 Amps.

To connect batteries in a series, use a jumper wire to connect the negative terminal of the first battery to the positive terminal of the second battery. Use another set of cables to connect the open positive and negative terminals to your application.

 

NOTE:

Never cross the remaining open positive and open negative terminals with each other, as this will short circuit the batteries and cause damage or injury.

It is best to be sure the batteries you’re connecting have the same voltage and capacity rating. Otherwise, you may end up with charging problems, and shortened battery life.

 

Parallel

 

The other type of connection is Parallel. Parallel connections will increase your current rating, but the voltage will stay the same. In the diagram to the left, we’re back to 6 Volts, but the Amps increase to 20. It’s important to note that because the amperage of the batteries increased, you may need a heavier duty cable to avoid the cables burning out.

To join batteries in parallel, use a set of cables to connect both the positive terminals and another set of cables to connect both the negative terminals of both batteries to each other. Negative to negative and positive to positive. You then connect your load to ONE of the batteries, but both drain equally.

 

joined in series and parallel

 

It is also possible to connect batteries in what is called a Series/Parallel configuration This may sound confusing, but we will explain below. This is the way you can increase your voltage output and current rating. To do this successfully, you need at least 4 batteries

 

If you have two sets of batteries already connected in parallel, you can join them together to form a series. In the diagram on the left, we have a bank that produces 12 Volts and has 20 Amp Hours.

Don’t get lost now. Remember, electricity flows through a parallel connection just the same as it does in a single battery. It can’t tell the difference. Therefore, you can connect two parallel connections in a series as you would two batteries. Only one cable is needed, a bridge between a positive terminal from one parallel bank to a negative terminal from the other parallel bank.

It’s alright if a terminal has more than one cable connected to it. It is necessary to successfully construct these kinds of battery banks.

In theory, you can connect as many batteries together as you want. But when you start to construct a tangled mess of batteries and cables, it can be very confusing, and confusion can be dangerous. Keep in mind the requirements for your application, and stick to them. Also, use batteries of the same capabilities. Avoid mixing and matching battery sizes wherever possible

Always remember to be safe, and keep track of your connections. If it helps, make a diagram of your battery banks before attempting to construct them. Good luck!

 

 

 

.

 

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *